LVM Aerogen wind generator

Aerogen is environmentally friendly and gives power whenever the wind blowsand can keep the batteries topped-up. Available in 12V or 24V
Aero2gen: For small boats with limited space & installations needing only a low charging rate to maintain the battery.
Aero4gen: For boats up to about 11m
Aero6gen: For larger boats.
No maintenance is required. With all 'Aerogen' models, a regulator is recommended to prevent over charging of the battery. Mounting hardware is manufactured from stainless steel. For land installations exist the furled wind generators which furl automatically at wind speeds above 40 knots.

Safe-T QC steering system & installation manual

SEASTAR SOLUTIONS SAFE-T QC STEERING SYSTEM KIT




by: Seastar Solutions


This is one of the most popular steering system for sterndrives, inboards and other power-assisted applications in which No-Feedback systems are not required. Easy to install by yourself, thanks to no-tools-needed cable connection at the helm. Works with steering wheels up to 16" diameter and speeds up to 50 mph. For use on Single I/O & O/B to 235hp and Twin engine to 230hp.
Kit Includes: Cable, Helm, Bezel Kit, and Hardware.

Rule automatic float switch. Installation.

The Rule-A-Matic float switch provides boat owners with safety precaution. The bilge pump empties the boat of water to prevent it from sinking. The Rule float switch detects when the water rises to a certain level, then automatically turns on the bilge pump and it empties the water from the boat even if you are not aboard. Once the pump finishes emptying the water, the switch turns it off.

Installation

1 Remove the power source from the pump. Take out the negative wire from the threaded post of the boat's negative battery terminal.

2 Put the Rule float switch close to the bilge pump at same level or a little bit higher than the pump.

3 Attach the float switch to the hull. 

4 Run the float switch wiring to the bilge pump manual control switch. Run the wiring along the side of the boat avoiding consistently wet areas. 

5 Remove the pump manual switch and insert the three-way switch. Attach the power wire to the three-way switch's line terminal. Connect the bilge pump's old manual wire to one of the switched terminals on the three-way switch. Fasten one of the Rule-A-Matic float switch wires to the remaining switched terminals on the three-way.

6 Reconnect the bilge pump negative cable to the battery's negative.

7 Put the three-way switch to "Off" and manual and the switch in automatic. Pump must remain off. With the switch in the automatic position, water the boat. Once the water level reachs the Rule-A-Matic float switch, the pump will turn on and drain the boat. The three-way will remain in the automatic position.

Anodes with Wear Indicator

Performance Metals (USA) patended this simple wear indicator system. A plastic indicator is assembled in the anode and appears once the anode has worn to half its original size.